Allen Bradley 2090-CDNPBMP-10S60 Used Surplus

The Allen-Bradley 2090-CDNPBMP-10S60 cable is a 60-meter power cable. It is compatible with the MP series motors from the Kinetix product line. Cables like the 2090-CDNPBMP-10S60 cable are usually shipped and stored in a coil. The cables usually retain this coil shape until they are straightened by the users. To straighten any long cable like the 2090-CDNPBMP-10S60 cable, it should be laid on the floor in a straight line. A short cable can also be hung from its mid-point to straighten it out. Straightening the cables enables easier installation, especially between devices that are some distance apart. The following precaution should be observed when a cable like the 2090-CDNPBMP-10S60 cable is being installed in a servo system: the power to the drive should always be removed prior to cable connection and disconnection to prevent arcing or unexpected motor motion.

Additional precautions which should be followed during cable installation include grounding the shielded cables at one point at a minimum (on factory-supplied cables, the shield is connected to the connector housing, a part of the shield is exposed, or the shield is connected to a ground wire). The excess length of a power cable should not be gathered or coiled because doing so can lead to heat generation. It should instead be positioned so that heat can dissipate freely, and unused wires should not be connected but should rather be trimmed off and finished to prevent accidental contact with wire shields or with other wires. The maximum cable length for the Kinetix 5500 drives is 50 meters and for Kinetix 5700 drives, it is 90 meters. The installers and operators should check the particular drive specifications to confirm the maximum cable length recommendations.