Allen Bradley 1336-BDB-SP64D Used Surplus

The Allen-Bradley’s 1336-BDB-SP64D is a Gate Drive Board features a Horsepower of 3 and operates on 460 Volts AC. It belongs to the family of PCB Gate Drive Board Series. This Gate Drive Board Module contains brake chopper modules each of which features a thermostat which helps to provide protection to the board so that it cannot be overheated and go through component damage. The user can set parameter 11 to “disabled”, but only when the dynamic braking is installed in the 1336-BDB-SP64D Gate Drive Board. The 1336-BDB-SP64D PCB Gated Drive Board can also be programmed to “ramp-to-stop”, only during braking for deceleration. All the brake module ratings contained in this drive contain a fault contact which helps to provide a remote output signal. All the installation instructions to do with this brake chopper module are very important. The brake chopper module is to be installed in a vertical position. The brake modules should also be spaced out living a minimum clearance of 152.4 millimeters.

All the brake resistor banks that are featured in the 1336-BDB-SP64D PCB Gate Drive Board Series should be mounted externally to the enclosure by the user or an experienced technician. The surface on which this Gate Drive Board is to be mounted should also be non-combustible. At times, the brake chopper could use more than one module. If this is the case, then the additional modules should be mounted within 10 feet of the chopper module. The measurements should be exact. The user should also put dependent applications into consideration during installation.